We had a great week at the Wire Processing Expo in Milwaukee with our partner GLW GmbH from Germany, and one thing became obvious very quickly:
The new LC 160 drew a tremendous amount of attention.
Why?
Because it addresses one of the biggest challenges manufacturers and panel builders are facing right now:
⚡ Labor efficiency ⚡ Repeatability ⚡ Throughput ⚡ Consistent wire preparation
Visitors to the booth immediately understood the value of reducing manual wire processing steps while improving accuracy and consistency.
The response wasn’t just about automation for the sake of automation.
It was about solving real production problems:
- reducing operator variability
- increasing output
- improving quality
- and helping skilled workers focus on higher-value tasks
That conversation came up repeatedly throughout the show.
As labor becomes harder to find and production demands continue to increase, equipment like the LC 160 is becoming less of a luxury and more of a competitive advantage.
The LC 160 cuts 28 – 6 AWG conductors in either manual, sequential (set number and length) or programmable (repeat customer) modes. A de-reeler is sold separately. If you want to add a quality wire cutting machine to your operation – look no further – the LC 160 is for YOU !
Here are the full Specs on the LC 160 :
The level of interest and engagement around this machine exceeded our expectations, and we’re excited about what’s ahead.
Thanks to everyone who stopped by Booth 1503 to see it in action.
https://www.americanelectrical.com/item/all-categories-automated-tools/automated-cutting/lc160
